background image

1

English

SAFETY PRECAUTIONS

!

 CAUTION

Please take note of the following important points when
installing.
• Ensure that drainage piping is connected properly.

If the drainage piping is not connected properly, it may
cause water leakage which will dampen the furniture.

• Ensure that the unit’s panel is closed after service or

installation.

Unsecured panels will cause the unit to operate noisily.

• Air swing connector and LED wire connector shall be

inside the control box.

• Sharp edges and coil surfaces are potential locations which

may cause injury hazards. Avoid from being in contact
with these places.

• Before turning off the power supply set the remote

controller’s ON/OFF switch to the “OFF” position to
prevent the nuisance tripping of the unit. 

If this is not done,

the unit’s fans will start turning automatically when power
resumes, posing a hazard to service personnel or the user.

• Do not operate any heating apparatus too close to the air

conditioner unit. 

This may cause the plastic panel to melt or

deform as a result of the excessive heat.

• Ensure the color of wires of the outdoor unit and the

terminal markings are same to the indoors respectively.

• IMPORTANT : DO NOT INSTALL OR USE THE AIR

CONDITIONER UNIT IN A LAUNDRY ROOM.

!

 WARNING

• Installation and maintenance should be performed by

qualified persons who are familiar with local code and
regulation, and experienced with this type of appliance.

• All field wiring must be installed in accordance with the

national wiring regulation.

• Ensure that the rated voltage of the unit corresponds to

that of the name plate before commencing wiring work
according to the wiring diagram.

• The unit must be GROUNDED to prevent possible hazard

due to insulation failure.

• All electrical wiring must not touch the water piping or

any moving parts of the fan motors.

• Confirm that the unit has been switched OFF before

installing or servicing the unit.

• Risk of electric shock, can cause injury or death.

Disconnect all remain electric power supplies before
servicing.

• DO NOT pull out the power cord when the power is ON.

This may cause serious electrical shocks which may result
in the fire hazards.

• Keep the indoor and outdoor units, power cable and

transmission wiring, at least 1m from TVs and radios, to
prevent distorted pictures and static. {Depending on the
type and source of the electrical waves, static may be heard
even when more than 1m away}.

570

570

250

640
408

640

408

364

364

75

98

Indoor Unit: FWF02AAYNMV1 / FWF03AATNMV1 / FWF04AATNMV1

All dimensions are in mm/ (in)

SEE DETAIL A

WATER INLET

WATER OUTLET

   

   

OUTLINE AND DIMENSIONS

DETAIL A

Summary of Contents for FWF02AATNMV1













Reviews: