English
15
7. WHEN THE OPTIONAL REMOTE CONTROLLER (BRC1E model) IS USED
AS A CONTROL PANEL
(Remote controllers except the optional BRC1E cannot be incorporated
into the main unit.)
• The optional remote controller (BRC1E) can be incorporated into this unit and used as a control panel.
1. Open the remote controller, and connect the remote controller wiring (accessory).
For wiring procedures, refer to the “remote controller installation manual”.
(There is no polarity for the remote controller wiring.)
1) Remove the upper case.
Insert a flathead screwdriver into the concaved portion of the lower case (at 2 positions), and then
remove the upper case.
CAUTION
• The printed circuit board of the remote controller is attached to the upper case. Be careful not to scratch the
board with the screwdriver.
•
Be careful not to adhere any dust or liquid to the printed circuit board of the removed upper case.
2) Cut off the shaded part of the lower case, and then fix the case to the cover (7) using screws (11).
Upper case
Lower case
Insert the screwdriver and twist it lightly to
remove the case.
Screwdriver
Fig. 20
Screw (11) (M4)
(Tightening torque : 0.6 ± 0.1N · m)
Lower case
Lower case assy
Shaded part
Cover (7)
(accessory)
(accessory)
Fig. 21
3PEN486970-1D.book Page 15 Monday, July 24, 2017 8:54 AM
