background image

8 Troubleshooting

Operation manual

11

35D5V1B6
Split system air conditioners
3P520336-16T – 2021.10

7.2

To clean the indoor unit and user
interface

NOTICE

▪ Do  NOT  use  gasoline,  benzene,  thinner,  polishing

powder  or  liquid  insecticide. 

Possible  consequence:

Discoloration and deformation.

▪ Do  NOT  use  water  or  air  of  40°C  or  higher. 

Possible

consequence: 

Discoloration and deformation.

▪ Do NOT use polishing compounds.

▪ Do 

NOT 

use 

scrubbing 

brush. 

Possible

consequence: 

The surface finishing peels off.

▪ As an end user, you may NEVER clean inside parts of

the unit by yourself; this work must be performed by a
qualified service person. Contact your dealer.

DANGER: RISK OF ELECTROCUTION

Before  cleaning,  be  sure  to  stop  the  operation,  turn  the
breaker  OFF  or  pull  out  the  supply  cord.  Otherwise,  an
electrical shock and injury may result.

1

Clean  with  a  soft  cloth.  If  it  is  difficult  to  remove  stains,  use
water or a neutral detergent.

7.3

To clean the front panel

1

Clean the front panel with a soft cloth. If it is difficult to remove
stains, use water or a neutral detergent.

7.4

About the air filters

Operating the unit with dirty filters means that the filter:

▪ CANNOT deodorise the air,

▪ CANNOT clean the air,

▪ poor heating/cooling,

▪ causes odour.

7.5

To clean the air filters

1

Push the tab at the centre of each air filter, then pull it down.

2

Pull out the air filters.

2

1

3

Wash  the  air  filters  with  water  or  clean  them  with  a  vacuum
cleaner.

4

Soak in lukewarm water for about 10 to 15 minutes.

5

Install all filters back in their original positions.

INFORMATION

▪ If the dust does NOT come off easily, wash them with a

neutral detergent diluted in lukewarm water. Dry the air
filters in the shade.

▪ It  is  recommended  to  clean  the  air  filters  every  2

weeks.

7.6

To take following items into
account before a long idle period

Operate the unit in 

fan only

 mode for several hours to dry the inside

of the unit.

1

Press 

 and select fan only operation.

2

Press 

 to start operation.

3

After operation stops, turn the breaker off.

4

Clean the air filters and replace them in their original position.

5

Remove the batteries from the user interface.

INFORMATION

It  is  recommended  to  have  periodical  maintenance
performed  by  a  specialist.  For  specialist  maintenance,
contact  your  dealer.  Maintenance  costs  shall  be  borne  by
the customer.

In  certain  operating  conditions  the  inside  of  the  unit  may
get dirty after several seasons of use. This results in poor
performance.

8

Troubleshooting

If one of the following malfunctions occur, take the measures shown
below and contact your dealer.

WARNING

Stop  operation  and  shut  OFF  the  power  if  anything
unusual occurs (burning smells etc.).

Leaving  the  unit  running  under  such  circumstances  may
cause  breakage,  electrical  shock  or  fire.  Contact  your
dealer.

The system MUST be repaired by a qualified service person.

Summary of Contents for FTXF25D5V1B6

















Reviews: