![background image](http://html1.mh-extra.com/html/daikin/ftnv20jvak/ftnv20jvak_installation-manual_2459378010.webp)
8
Bottom or side piping
(For FTS/FTYS only)
Cut off pipe port cover with a copping saw.
For bottom piping: On the bottom of the front grille
For side piping: On the side cover (front grille side and unit side)
Apply the blade of the copping saw to the notch, and cut off the pipe port cover along the uneven inner surface.
1)
ü
ü
After cutting off the pipe cover, perform filing.
Remove the burrs along the cut section using a half round needle file.
Wrap the inter-unit wire, refrigerant pipes and drain hose together with insulation tape.
Then, insert the drain hose and refrigerant pipes into the wall hole after inserting them into the cut out piping hole
opened.
2)
3)
NOTE
Be careful not to let chips enter the driving section of the arm.
Be careful not to put pressure on the lower front panel.
ü
ü
Left-side
piping
Right-bottom piping
Right-side
piping
Bind refrigerant pipe and drain hose
together with adhesive vinyl tape.
Left-bottom piping
The figure shows the case of left bottom piping
Front grille side
Side cover
(front grille side)
1-IM-5WMJ(R)-0714(2)DAIKIN(SASO)8 8
1-IM-5WMJ(R)-0714(2)DAIKIN(SASO)8 8
5/22/15 4:27:16 PM
5/22/15 4:27:16 PM