Accessories ®
~
®
ITEM
QTY.
Remarks
ITEM
QTY.
Remarks
®
Mounting plate
1
0
®
Remote controller holder fixing screw (M3 x 20L
2
*
@
Mounting plate fixing screw (M4 x 25L)
617"
0
<D
4-Core wire (3. 7M)
1
*
©
Wireless Remote Controller
1
0
®
Tie wrap
6
*
@
Drv batterv (AAA)
2
*
®
Accessory filter
1/2*
*
®
Indoor Unit Fixina Screw (M4 x 12L)
2
0
®
Gas pinA (3.0Ml
1
*
®
Operation Installation Manual
1+1
0
(9)
Liquid pipe (3.0M)
1
*
@
E-Waste (Guideline)
1
0
®
Drain socket
1
*
(8)
Product warranty
1
0
®
Heat insulation tape
1
*
Q)
Remote controller holder
1
*
©
Wi-Fi manual
1
*
'O' Applicable for all models
'*
'Aoolicable onlv for selected models. ••• Quantity mav varv model to model.
!
Note: The accessories parts included with the unit displayed on the packing case name plate/ Label of indoor and outdoor packing case
TableNo.1
Precautions for Selecting a Location
• Before choosing the installation site, obtain user approval.
•btM•li•lehe
The ii
1d001 bi 1it
should be positioned in a place where:
1) the restrictions on the installation requirements specified
in "Indoor/Outdoor Installation Diagram" are met,
2) both the air inlet and air outlet are unobstructed,
3) the unit is not exposed to direct sunlight,
4) the unit is away from sources of heat or steam,
5) there is no source of machine oil vapour
(this may shorten the indoor unit service life),
6) cool air is circulated throughout the room,
7) the unit is away from electronic ignition type
fluorescent lamps (inverter or rapid start type) as they
may affect the remote controller range,
8) the unit is at least 1 m away from any television or radio set
(the unit may cause interference with the picture or sound),
9) the unit can be installed at the recommended height (1.8m),
10) no laundry equipment is nearby.
The outdoor unit should be positioned in a place where:
1) the restrictions on the installation requirements specified
in "Indoor/Outdoor Installation Diagram" are met,
2) drain water causes no trouble or problem in particular,
3) both air inlet and outlet have clear paths of air
(they should be free of snow in snowy districts),
4) the unit is in a clear path of air but not directly exposed
to rain, strong winds, or direct sunlight,
5) there is no fear of inflammable gas leakage,
6) the unit is not directly exposed to salt, sulfidized
gases, or machine oil vapour (these may shorten the
service life of the outdoor unit),
7) operating sound or hot airflow does not cause trouble
to neighbours,
8) the unit is at least 3m away from any television or
radio antenna.
Outdoor Unit Installation Space Requirements
Lh
CAUTION------------
When carrying the outdoor unit during installation, wear gloves to avoid injury.
• Position the unit on a horizontal surface.
Any tilt in the unit (front to back, right to left) should be 3
°
or less to the horizontal.
• Where a wall or other obstacle is in the path of the outdoor unit's
intake or exhaust airflow, follow the installation space requirements below.
• For any of the below installation patterns, the wall height on the
outlet side should be 1200mm or less.
j Wall facing one side
I
More than 100
More than 350
j Walls facing two sides
I
Viewed from
the front
Direction
r
of air 1200
More
...()..
IQ
or less
Side view
I " : �
More than 35 ........,-....
u
=....,
..Q...
than 100
---
More than 50
Top view
IJll
More than 50
Viewed from
the side
!
Walls facing three sides
I
1
LJ
I
M�han 100
.D,
I
More than 350
Top view
unit:mm
2
Summary of Contents for F
Page 20: ......