8
PRODUCT IDENTIFICATION
MODEL #
MFG #
DESCRIPTION
AFE18-60A
N/A
Fossil Fuel Kit.
The AFE18-60A control is designed for use where the indoor coil is located
above/downstream of a gas or fossil fuel furnace when used with a heat pump. It will
operate with single and two stage heat pumps and single and two stage furnaces
AMU1620
AMU1625
AMU2020
AMU2025
GMU1620
GMU1625
GMU2020
GMU2025
P1251305F
P1251306F
P1251307F
P1251308F
N/A
Media Air Cleaner
. The AMU* and GMU* Media Air Cleaner is a high efficiency air filtration
device designed to remove dirt, dust, pollen and other microscopic particles from the air
passing through it. Flexible performance range up to 2,000 CFM capacity. T
ASAS-10
ASAS-11
ASAS-12
ASAS-18
P1251301F
P1251302F
P1251303F
P1251304F
Electronic Air Cleaner
. The High-Efficiency Electronic Air Cleaner is designed to remove
air contaminants down to .01 microns. Carbon filters (optional) remove odors. Dual
indicator lights show unit operation at a glance. Electronic proving switch cycle
DCVK-20
CVENT-2
DCVK-30
CVENT-3
P1254001F
P1254002F
Concentric Vent Kit
. For use with high efficiency furnace models
.
This kit is designed to
allow terminations of a direct vent furnace to be "concentrically" vented through a wall or
roof. This kit allows a single penetration to support terminations for bo
0170K00000S
N/A
Side Wall Only Concentric Vent Kit
. For use with high efficiency furnace models
.
This kit
is to be used with 2" - 3" vent systems. The vent kit must terminate outside the structure.
This kit is NOT intended for use with single pipe (indirect vent) instal
0170K00001S
N/A
Side Wall Only Concentric Vent Kit
. For use with high efficiency 90% furnace models
.
This kit is to be used with 2" only vent systems. The vent kit must terminate outside the
structure. This kit is NOT intended for use with single pipe (indirect vent) in
EFR02
P1221001
P1221002F
External Filter Rack Kit
. This kit is intended to provide a location, external to the furnace
casing, for installation of a permanent filter. The rack is mounted over the indoor air
blower compartment area of either side panel, and provide filter retentio
LPLP03
N/A
LP Gas Low Pressure Kit
. Designed for application on 80% and 90% single-stage and
two-stage gas fired furnace products installed on LP gas listed in this manual. This kit
includes harness adaptors to work with White-Rodgers single & two stage gas valves,H
RF000142
N/A
Vent Drain Coupling
. For use when the furnaces is installed in horizontal left position and
the internal elbow is removed.
May also be used in the combustion air intake if condensation is an issue.
CFSB17
CFSB21
CFSB24
N/A
Counterflow Subbase Kit
. For use with Daikin® Brand 96% two stage 34.5 furnace
model. These kits are available for the following furnace width: 17.5" wide (CFSB17), 21"
wide (CFSB21, and 24" Wide CFSB21. The kit must be used to prevent excessive
temperature from reaching combustible materials, if the furnace is installed on
combustible floor. This subbase effectively separated the furnace base and plenum from
combustile materials. To ensure safe installation, do not install the counterflow floor base
directly on carpeting, tile or other combusible material other than wood flooring.
