Daikin CTXM15M2V1B, Installation Manual

Page: 8 / 18


English 5
Englis
h
En
gl
is
h
Indoor Unit Installation
1.
Installing the mounting plate
• The mounting plate should be installed on a wall which can support the weight of the indoor unit.
1) Temporarily secure the mounting plate to the wall, make sure that the panel is completely level, and mark the boring points
on the wall.
2) Secure the mounting plate to the wall with screws.
Recommended mounting plate retention spots and dimensions
2.
Boring a wall hole and installing wall embedded pipe
• For walls containing metal frame or metal board, be sure to use a wall
embedded pipe and wall cover in the feed-through hole to prevent possible
heat, electrical shock, or fire.
• Be sure to caulk the gaps around the pipes with caulking material to
prevent water leakage.
1) Bore a feed-through hole of 65/80mm in the wall so it has a down slope
toward the outside.
2) Insert a wall pipe into the hole.
3) Insert a wall cover into wall pipe.
337
810
A
A
294
44.5
170
142
170
447
60
435
990
1040
170
151.5
52
19.5
126.5
48 60
52
300
19.5
117
68 68
44.5
137 137
337
50
213 237
170
Place the pipe port cover
in this pocket.
Place a leveler
on these tabs.
Recommended mounting plate
retention spots (7 spots in all)
Through-the-wall
hole
I 65
Drain hose position
Gas pipe end
Liquid pipe end
Use a tape measure
as shown.
Position the end of
the tape measure at .
The removed pipe
port cover can be
kept in the mounting
plate pocket.
Mounting
plate
Removed pipe
port cover
A
Class 15/20/25/35/42:
Class 50/60/71:
PIPING HOLE
CENTER:170mm
TO THE LEFT
PIPING HOLE
CENTER:170mm
TO THE LEFT
Place a leveler
on these tabs.
Gas pipe end
Liquid pipe end
Through-the-wall
hole
I 80
Drain hose
position
Recommended mounting
plate retention spots
(5 spots in all)
(Outline of back side)
(Outline of front side)
Inside Outside
Caulking
Wall embedded pipe
(field supply)
Wall hole cover
(field supply)
Wall embedded pipe
(field supply)
65/ 80
3PEN393185-7L.book Page 5 Friday, February 26, 2016 7:49 AM