1.
Press
one or more times to select the operation mode.
Result:
The mode will be set as follows:
2.
Press
to
start
operation.
Result:
and the selected mode are displayed on the LCD.
3.
Press
or
one or more times to lower or raise the
temperature
.
Cooling
operation
Heating
operation
Automatic
operation
Drying or Fan
only operation
18~32°C
10~30°C
18~30°C
—
Note:
When using
drying
or
fan only
mode, you cannot adjust
the temperature.
4.
Press
to
stop
operation.
Result:
disappears from the LCD. The operation lamp
goes off.
4-3-2
Airflow rate
1.
Press to choose:
5 airflow rate levels, from “ ” to “ ”
Automatic operation
Indoor unit quiet operation. When the airflow is set
to “ ”, the noise from the unit will be reduced.
Note:
When using
drying
operation mode, you CANNOT adjust
the airflow rate setting.
To adjust the airflow rate
1.
Press
to change the airflow setting as follows:
4-3-3
Airflow direction
When.
Adjust the airflow direction as desired.
What.
The system directs the airflow differently, depending
on the user selection (swinging or fixed position). It does so by
moving horizontal blades (flaps) or vertical blades (louvres).
Setting
Airflow direction
Vertical automatic
swing
Moves up and down.
Horizontal
automatic swing
Moves from side to side.
+
3-D airflow
direction
Moves simultaneously up and down
and from side to side
[—]
Stays in a fixed position.
CAUTION
•
ALWAYS use a remote controller to adjust the position of the
flaps and louvres. When the flaps and louvres are swinging
and you move them forcibly by hand, the mechanism will
break.
•
Be careful when adjusting the flaps and louvres. Inside the
air outlet, a fan is rotating at high speed.
Note:
The movable range of the flap varies according to the
operation mode. The flap will stop at the upper position when
the airflow rate is changed to low during the up and down swing
setting.
a
b
a
Flap range in cooling or drying operation
b
Flap range in heating or fan only operation
To adjust vertical airflow direction
1.
Press
.
Result:
appears on the LCD. The flaps (horizontal
blades) will begin to swing.
2.
To use fixed position, press
when the flaps reach
the desired position.
Result:
disappears from the LCD. The flaps will stop
moving.
To adjust horizontal airflow direction
1.
Press
.
Result:
appears on the LCD. The louvres (vertical
blades) will begin to swing.
2.
To use fixed position, press
when the louvres reach
the desired position.
Result:
disappears from the LCD. The flaps will stop
moving.
To use 3-D airflow direction
1.
Press
and
.
Result:
and
appear on the LCD. The flaps (horizontal
blades) and louvres (vertical blades) will begin to swing.
2.
To use fixed position, press
and
when the
flaps and louvres reach the desired position.
Result:
and
disappear from the LCD. The flaps
and the louvres will stop moving.
8
01_EN_3P620957-1.indd 8
26-Jun-20 10:17:29 AM
