3
3.
REMOTE CONTROLLER INSTALLATION
<Installing wireless remote controller>
• Do not throw the remote controller or impose large shocks.
Also, do not store where it may be exposed to moisture or
direct sunlight.
• When operating, point the transmitting part of the remote
controller in the direction of the receiver.
• The direct transmitting distance of the remote controller is
approximately 23 ft..
• The signal cannot be transmitted if something such as cur-
tains blocks the receiver and the remote controller.
•
Installing to a wall or a pillar
1. Fix the remote controller holder (5) with
the screws (8).
2. Slide the remote controller (4) into the
remote controller holder (5) from the top.
•
How to put the dry cell batteries
1. Remove the back cover of the remote control-
ler (4) to the direction pointed by the arrow
mark.
2. Put the dry cell batteries.
Use two LR03<AM4> dry cell batteries (6).
Put the dry cell batteries correctly to fit their
(+) and (–).
3. Close the back cover as before.
4.
RECEIVER INSTALLATION
4-1. Preparations before installation
Remove the suction grille, the decoration panel and the
protection net according to the installation manual
attached to the indoor unit.
4-2. Determination of address and MAIN/SUB remote con-
troller
If setting multiple wireless remote controllers to operate in
1 room, perform address setting for the receiver and the
wireless remote controller. If setting multiple wired remote
controllers in 1 room, change the MAIN/SUB switch of the
receiver.
4-3. Setting procedure
• Setting the receiver
Set the wireless address switch (SS2) on the transmis-
sion PC-board assembly (2) according to the table below.
CAUTION
Change the setting so that the internal electronic equipments
are not damaged with a pen etc.
When using both a wired and a wireless remote controller
for 1 indoor unit, the wired controller should be set to MAIN.
Therefore, set the MAIN/SUB switch (SS1) of the receiver
to SUB.
4-4. Receiver installation
WARNING
Be sure to turn off the power before installtion.
• Remove the name plate mount of the indoor unit.
(1) Inset the tip of the flat blade (–) screwdriver into the
place shown by the convex mark
{
(both A and B) of
the name plate.
(2) Tilt the screwdriver in the direction shown by the arrow.
(both A and B)
Unit No.
Wireless
address
switch
(SS2)
No.1
No.2
No.3
123
123
123
The side painted black indicates
the switch knob position.
Transmission PC-board
assembly (2)
MAIN/
SUB
switch
(SS1)
MAIN
SUB
S
M
S
M
Name plate
mount
Name
plate
(2)
(3)
(1)
B
D
C
Side panel
assy (right)
Projection
Receiver
assembly (1)
Notch
Penetrating hole
Bottom plate