Daikin BRC2E52C7, Operation Manual

Page: 25 / 64

BRC2E52C7 / BRC3E52C7 Operation manual
4P368042-1 - 2014.02
24
Quick Reference of Main Menu Items
Setting and display items Description
Reference
page
Energy
Saving
Options
(1)
Energy Saving List Enable or disable the "Energy Saving
Options".
36
Setpoint Range The setpoint temperature range can be
restricted for the Cooling and Heating Mode.
37
Setback Condition Set the setback differential temperature after
which the unit will turn back OFF.
38
Sensing Sensor
(Low)
(
²
)(
³
)
(only if the sensing
sensor is installed)
When no people are detected during a set
time, this function will automatically change
the air conditioning target temperature.
If people are detected, it will return to the
normal setpoint temperature.
39
Sensing Sensor
(Stop)
(
²
)(
³
)
(only if the sensing
sensor is installed)
When no people are detected during a set
time, this function will automatically stop the
air conditioner.
40
Setpoint Auto Reset Change the temperature setpoint to a preset
temperature setpoint after running for a set
period of time, even if the temperature
setpoint has been changed.
• Possible to set from 30 to 120 minutes in 30
minute increments.
41
Off Timer
The system is turned off automatically after
the selected time each time the system is
activated.
• Possible to set in 10 minute increments
from 30 to 180 minutes.
42
Energy
consumption
(
²
)
(Only on SkyAir
models FCQG-F and
FCQHG-F)
An indicative energy consumption until now is
displayed. This enables the customer to
evaluate the trend of the energy consumption.
43
Note
• This function is not available when more
than 1 indoor unit is connected to the
remote controller.
• The displayed energy consumption is not
the result of a kWh measurement, but
results from a calculation with running data
of the unit.
• Some factors in this calculation are
absolute values, but other factors merely
result from interpolations with tolerance.
This explains why the readout may deviate
from the actual energy consumption.
1) Setback, Setpoint Range, Setback Condition and Setpoint Auto Reset should not be used when a centralised controller is connected.
2) Not supported when SkyAir RR+RQ outdoor units are connected.
This function cannot be used when group control is active.
In case of a simultaneous operation system, the system is controlled by the sensing sensor mounted in the master indoor unit.