13
EC Motor Speed Adjustment
The unit has been equipped with an EC motor and controller to allow customization of air flow
settings or noise levels. This adjustment can be done directly in the control panel (see Control Panel
section for more information).
Operating Instructions
Operating Environmental Conditions:
Temperature: 50-100
°
F
Humidity: Relative humidity: Up to 95%
Internal Fuse
The equipment is protected by an inline cartridge fuse. This fuse is located on the back of the unit,
close to the power cord. To access this fuse, twist the fuse holder from the cabinet-mounted fuse
housing. Check for blown fuses if control panel does not illuminate when the unit is powered on.
Internal Kill Switch
An internal kill switch has been installed on the back panel of the equipment. This switch is in the
Normally Closed position when the back panel of the device is installed. When the back panel of the
device is removed, the position of the switch moves to Normally Open and removes power from the
internal components of the unit.
QUICK START GUIDE & OPERATION (CONT’D)
Internal Kill Switch
Internal Fuse
Note:
If the unit does not seem to be operating correctly, it may be reset by switching the kill
switch to the ‘off’ position, then switching it back to the ‘on’ position after a few seconds.
