SDLC-207-104
16
● Notes after a setting change end
After setting change is completed, please check that set value has been changed with a set value display mode.
After confirming the changed set value when being different from the established set value, please establish
it once again.
● If a unit display (UNIT) is set up. (
９
)
● If a minimum value scaling (MIN) is set up.
Note(
９
) If you do not have the unit you wish to use, please use a combination of "no unit" setting and
seal (accessory).
Note(
10
) After set value changed, displays the change set value.
Note(
11
) The number of the top digit becomes "-"(minus) after 0 to 9.
Note(
12
) The number of digits other than the top digit becomes " ．"(decimal point) after 0 to 9.
However, if decimal point is in other digits, decimal point does not display.
(
10
)
U N I T
%
(Middle omission)
U N I T
%
U N I T
m
U N I T
m
U N I T
k W
U N I T
k W
ENT
ENT
ENT
UP
UP
UP
After deciding set value change, a setting
item symbol is blinking.
(UNIT is blinking.)
U N I T
UP
UP
With no unit
U N I T
%
ENT
(
10
)
(Middle omission)
M I N
0 0 0 . 0
M I N
1 0 0 . 0
M I N
0 1 0 . 0
M I N
- 0 0 . 0
M I N
0 9 0 . 0
M I N
0 0 0 . 0
M I N
0 0 0 . 0
(Middle
omission)
M I N
0 1 0 . 0
(Middle omission)
(
11
)
(
12
)
M I N
0 0 0 . 0
SHIFT
ENT
UP
SHIFT
ENT
UP
UP
UP
UP
UP
After deciding set value change, a setting item
symbol is blinking.
(Here, MIN is blinking.)
