Daihen varstroj VARMIG 231-i LCD, Owner'S Manual

Page: 47 / 100

15
⚫ Wire addition control function: - press the right button again to enter the wire addition control mode
and rotate the right button to select RUN/STOP
Feeding the welding wire
⚫
Remove the gas and contact nozzle from the burner. Remove the gas nozzle by turning it clockwise and
pulling it out at the same time. The contact nozzle unscrews from the contact nozzle adapter
⚫
With the appliance door open on the wire feeder side, press the torch switch and check that the wire travels
smoothly through the wheels of the mechanism for feeding the torch. Extend the cable and torch handle
and select the wire control function. This will run the feed motor at full speed to push the wire through the
torch spiral.
⚫
When the wire comes out of the torch body, press the torch switch or any button on the screen to stop
further automatic wire feeding.
⚫
Reassemble the contact and gas nozzle on the burner and cut off the excess wire. With this, you are ready
to weld
!
Actual welding current