5. Install the glass, using suction rubbers. Push the entire
glass surface lightly so that the glass may fit completely.
NOTE:
·
At this time, assembling should be performed while the
marks of the tinted section of the glass are aligned with
the windshield glass stoppers.
6. Using a spatula or the like, correct the adhesive agent
which has oozed out to the peripheral section of the glass,
as shown in the right figure.
7. Affix the windshield outside molding.
8. Cure the adhesive agent completely.
NOTE:
·
Observe the curing time of the adhesive agent speci-
fied by its manufacturer.
CAUTION:
·
Do not move the vehicle until the adhesive agent of the
windshield cures completely.
As for the following operations, refer to the front wind-
shield wiper section on the BE section.
9. Install the cowl top ventilator louver.
10. Install the hood-to-cowl top weatherstrip.
11. Install the front windshield wiper arms.
12. Ensure that no water leakage exists.
If any water leakage is found, repair it, as required, or re-
fix the front windshield glass.
BO–73
Glass
Adhesive agent
Dam
JBO00192-00164
JBO00193-00165
JBO00194-00000
