16
(2)
Mounting conditions
1) Horizontal or downward (front declined) within 15°
Fig. 10
Tilt tolerance for horizontal direction
2) Rotation direction within ±5°
Fig. 11
Tilt tolerance for the rotation direction
(3) Insert the hood of the sensor unit into the crankcase through the threaded portion (thread size: G3/4) of
the engine frame, screw in the hood to the specified length (threaded portion length of 15 mm: 10 turns
or more) after winding a sealing tape, and secure the hood with the lock nut through the supplied
sealing washer.
Note:
・
If the screw part is not rolled up by seal tape, Oil leak will be occurred from screw part to engine
outside.
・
If you use the special sealing washer (optional), it is not necessary to wind the sealing tape. If
you need this special sealing washer, please contact us
(4) Although the threaded portion is made of stainless steel and has sufficient strength, the case and the
front hood are made of plastics. When handling them, take care not to give undue force to them.
(5) Please do not install an obstacle to a radius of less than 100 mm from an installation hole of a sensor.
On sensor installation work, a sensor hits the obstacle, and there is the case that cannot screw.
Original content from www.daihatsu.cc
Issued to HORIZON TANKERS LIMITED S.A.
