.
...,
I
r
•
(~
.~~
I
1.00
I
Povver supply
Braking
Cushion
Closing
Opening
@-~-
Green: 100V Min.Max. S
F
5
F S
F
ned: Alarm
Speed
100
50-70
• Aft!!r adjusting any
0'
the speed adjusl-
menl
knobs. always
lurn the povver OFF
then ON to check the !!Hl!cl.
4.
Pressing
the test button lights
the sensor
indicator (red)
5.
Brake
force
adj ustrnent
Adjust the brake force so that
the low-speed
zone is set to 50-l00rnrn.
If
braking
is
excessively
weak, the door hits the door
frame at
high speed, or, when the door stops moving in the reverse
direction, it goes beyond the proper stopping point. If the
braking is excessively strong, the door judders to stop ..
If the cushion mode is set to Auto (factory-setting),
the slow
speed zone is automatically adjusted to 50 _60 mID regardless of
the slow-speed
zone setting.
6,
7.
High-speed
adjusters
(6:
for
opening speed, 7:
for closing speed)
(\
For proper adjustment, start with a low
speed,
then
gradually
increase
the setting so that the
slow-speed
zone is at least 50mm. The
closing
speed must be slower than the
opening
speed, for the safety reasons.
8.
Cushioning
speed
(low-speed)
adjuster
This adjusts the door speed
after
a brake is applied. Use if
the cushioning mode is "Fixed". Normally adjust to 50 -60
mm/sec. An excessively slow set ting
results in poor door
operation. See the slow speed section in the teaching
process.
9.
Open timer
This adjusts the door-open
time, from when
the sensor turns OFF to when the door
actually
starts to close. The adjustment
range is between
0.5 and 10 seconds. Normally
set it to 1 -2 seconds.
