DAIHAN-Sci.com or
ALL
for
LAB.com
Shopping Mall
DAIHAN Scientific, High Performance Dry Bath Heating Block "MaXtable
TM
H20"
8/22
3. Product Usage
3.1 Precautions for Use
You must read this manual carefully and completely before using.
The device should only be operated by laboratory personnel especially trained for
this purpose and familiar with all precautionary measures required for working in a
laboratory.
Be careful not to drop when transporting the product.
Place the device on a level, horizontal surface to support the capacity of the
device without vibration. If there is vibration, install the device on a support
material with enough space. Small place may cause the device to drop.
Please never tilt or lay the product doing during transportation.
Do not install at a dangerous place.
Do not operate the device where there are flammables. It could be caused serious
accidents like explosion or fire.
Do not use outdoors avoid overheating or electrical fault. The use in the place
where the sun continuously shines and can get rained on it is prohibited. It may
cause overheating or electrical fault of the product.
This product was manufactured to move normally at the rated voltage.
Confirm the voltage state before the installation of product.
(AC 230V, 50/60Hz, Single phase)
Do not install the product where it can get damp or in a dusty environment.
It may cause overheating or short circuit. (Pollution Degree 2)
If the product was moved or stored in high humidity state, identify the packaging
state of the product before use.
In case that the carton box or wooden box is soaked in water, consult with an
engineer about the matter. Do not operate the equipment before the safety is
confirmed. This wetting state may be the cause of an electric shock or a fire.
This product should be operated in a room with temperature maintain between 5
℃
and 40
℃
. Long-term use in an environment that exceeds the allowable range may
cause a malfunction.
The maximum relative humidity is 80% at 31
℃
and 50% at 40
℃
.
Do not install the product in a location at an altitude of over 2,000 meters. (6,562
feet).
The Sound Level of the buzzer is maximum 60dB in 1 meter distance when an
error is detected.
Do not install the product at gloomy place.
If the product is installed at gloomy place, the unexpected accident by the
movement mistake may occur.
3
