Daihan Scientific Ba Series, User Manual

Page: 5 / 43

DAIHAN-Sci.com or ALL for LAB.com Shopping Mall
5/20
2. Installation Information
2.1 Product Installation
1.
DO NOT lay the product on the floor or impose a shock on it. Otherwise, the product can get
internal damage.
2.
Install the product on the firm and flat floor and make sure to use it in a stable place.
3.
Avoid a place where static electricity or unstable power supply occurs.
4.
DO NOT install in a place which has the risk of vibration.
5.
DO NOT install in a place near a heater, or exposed to direct sunlight.
6.
DO NOT install in a door or a window in which wind reaches the scale.
7.
If water or organic solvent flows in the controller or main body of the product, a short circuit
may occur. Therefore, DO NOT install in a place with such flow-in risk.
8.
DO NOT put the scale in a wet place long. If the cold scale is put in a warm place, moisture can
be condensed. In this case, use the product after the scale is adapted to room temperature.
9.
This product is designed to be operated well at rated voltage. Therefore, check the voltage
before installing the product.
10.
Make sure to use the POWER CORD offered together with the product in order to install and
use the product.
11.
Install in a proper place, turn the leveling feet to make the air bubble of the level at the back
center adjusted at the center
12.
If a weighing dish is used, take a light and disposable paper (glassine paper) or plastic dish
which sells for laboratory experiments. If the capacity of a weighing dish is large, it is possible
to use the dish in line with the capacity of the scale.
13.
DO NOT get the product exposed to high humidity long. It is impossible to detect the
accumulation of high humidity which can occur when cold equipment is exposed to a warm
environment. In this case, power off the product and get it adapted to room temperature for
more than 2 hours.
2