Dahua Smart Box Series, User Manual

Page: 168 / 361

Standalone DVR User’s Manual
158
have enabled these two types at the same time, system can activate the trigger
snapshot when an alarm occurs, and otherwise system just operates the regular
snapshot.
Only the trigger snapshot supports this function. The regular snapshot function can
not send out picture via the email. But you can upload the picture to a FTP.
4.6.3 Motion detect record/snapshot
4.6.3.1 Motion detect record
a) From Main menu->Setting->Event->Detect, you can go to the following interface.
See Figure 4-42.
Figure 4-42
b) Select motion detect from the event type dropdown list. Select a channel from
the dropdown list and then check the enable button to enable motion detect
function.
c) Click Region Select button to set motion detect zone. There are
396(PAL)/330(NTSC) small zones. The green zone is current cursor position.
Grey zone is the motion detection zone. Black zone is the disarmed zone. You
can click Fn button to switch between the arm mode and disarm mode. In arm
mode, you can click the direction buttons to move the green rectangle to set the
motion detection zone. After you completed the setup, please click ENTER
button to exit current setup. Do remember click save button to save current setup.
If you click ESC button to exit the region setup interface system will not save your
zone setup.
d) Period: Click set button, you can see an interface is shown as in Figure 4-110.
Here you can set motion detect period. System only enables motion detect
operation in the specified periods. It is not for video loss or the tampering. There