10
Figure 2-12
Step 2
Connect the power cable, video cable, audio cable, RS-485 control cable, alarm cable, network
cable, high-frequency cable and optical fiber cable etc. well according to requirements, and then
use insulated rubber tape to twine the cable connection well respectively to make it waterproof.
Note
The video port is covered with heat-shrinkable tube with high shrinkage ratio, it needs to heat
and shrink the tubes on both sides after the video port is well connected, which is to make sure
the video port is moistureproof and waterproof.
Step 3
Fix the speed dome together with bracket on the wall, which is shown in Figure 2-13.
Figure 2-13
2.5.1 Install Quick Mount Connector
Twine Teflon tape over the thread of quick mount connector and rotate it into the tube thread of
wall-mounted bracket, use M4 stainless screw to fix it, which is shown in Figure 2-14, the thread
standard is G1 1/2 tube thread.
