47
4.2.2.4.1.6 Activate Pattern Function
Figure 4-27, input mode value in the No. blank, and click pattern button.
4.2.2.4.1.7 Auto Scan Setup
Figure 4-26, click border button. The interface is shown as in
Please go to Figure 4-23
, use direction arrows to select camera left limit
Then please go to
Figure 4-31 and click left limit button
Repeat the above procedures to set right limit.
Figure 4-31
4.2.2.4.1.8 Activate Auto Scan
, click “Auto Scan” button, the system begins auto scan. Correspondingly, the auto
scan button becomes Stop button. Click stop button to terminate scan operation.
4.2.2.5 Aux function
In Figure 4-27, click Page switch button, you can see an interface is shown as below. See Figure
4-32. Here you can set auxiliary function. The aux value has relationship with the Aux button of
the decoder.
Figure 4-33
Click Page switch button, system goes to the following interface. The options here are defined by
the protocol. The aux number is corresponding to the aux on-off button of the decoder. See Figure
Direct Aux: It includes three items.
It is to use RS485 command to control the peripheral device light on/off. Make sure the
connected peripheral device supports this function. Select Light from the dropdown list
and click On to turn the light on and click Off to turn the light off.
It is to use RS485 command to control the peripheral device wiper. Make sure the
