68
Figure 4- 49
Step 2. Select slot, click Bind.
Step 3. Select decoder you want to unbind, click OK.
Note:
You can unbind or reboot sub decoding box.
4.5.2.21 Display Setup
You can set corresponding slot-channel output, including resolution, display, HUE, brightness,
contrast, left/right/top/bottom margin adjustment. Display includes hot swap and force. In global
config, enable Keep last frame to show the last frame when there is no stream. If you do not
enable this function, the screen will be dark, and show prompt as “video requesting…”. Use
RTSP to connect platform, use pull mode of this protocol. If you enable RTSP, then it will uses
RTSP protocol to exchange. Net TV push stream is push mode, it is disabled by default. Push
mode: At device-end, each TV open one port, and Client connects to this port, send data over.
Push stream is simpler compare to others.
Summary of Contents for DH-M70-D-0204HO
