63
Figure 4- 44
Slot and channel: Select channel for speed dome input.
Port: Select port to control signal output.
PTZ type: Select either local or other PTZ.
Protocol: Select the corresponding dome protocol.(such as PELCOD)
Address: Set corresponding dome address. Default value is 1. Please note your setting here
shall comply with your dome address; otherwise you cannot control the speed dome.
Baud Rate: Select corresponding dome baud rate for your speed dome. Default setting is 9600.
Data Bit: Default value is 8. Please set according to the speed dome dial switch setting.
Stop bit: Default value is 1. Please set according to the speed dome dial switch setting.
Parity: Default setting is none. Please set according to the speed dome dial switch setting.
When you completes all above settings, click save to return to monitoring interface.
When board card at corresponding slot is fiber encoding card, HDCVI encoding card, you may
set countercharge front-end function. After above settings are finished, you can countercharge
front-end via video line, like RS485 control.
4.5.2.17 Video Output Title
The interface can modify output channel name, control ID is no. of output channel. See Figure 4-
Summary of Contents for DH-M70-D-0204HO
