User’s Manual
13
3.5.7
Initializing Controller
Description
Initialize the alarm controller.
Due to the inconvenience of entering letters on the keypad, the passcode of the admin account
which initializes the controller uses the following rules.
After executing the command with a digital passcode (3–27 digits) to successfully initialize the
controller, the actual passcode is admin + the digital passcode.
If the passcode is a mix of numbers and letters (8–32), after successful initialization, the actual
passcode is the mixed passcode.
Command
Enter passcode * + 21 + * + passcode of admin.
Example
Admin (default passcode is 1234) initializes the controller, and sets the admin user passcode to
admin123.
Under global mode, enter 1234*21*123.
Press
Enter
.
3.5.8
Restoring to Default
Description
Restore parameters to default settings, including alarm, alarm output, alarm subsystem, keypad,
arm/disarm, main battery failure, undervoltage, tamper alarm, call alarm receiving center, PSTN
offline, subsystem status, network disconnection, IP conflict, MAC conflict and emergency alarm.
Command
Enter pa * + 22.
Example
Admin (default passcode is 1234) restores the controller to default settings.
Under the global mode, enter 1234*22.
Press
Enter
.
