![background image](http://html1.mh-extra.com/html/dahua-technology/dh-pfr4k-b240/dh-pfr4k-b240_user-manual_3218115037.webp)
User’s Manual
31
Radar calibration is only for Radar-PTZ Linkage, and you can skip this setting as needed.
Select a PTZ camera in
PTZ
Camera List
, and then enter the username and password used
Step 1
to log in to the web interface of the camera.
You must log in to the PTZ camera before calibration. For details, see "4.1.2 PTZ
Camera".
If you need to link multiple cameras, click
PTZ
Camera List
at the upper-left corner
above the live image to switch to another camera, and then repeat the following
steps.
Log in to the camera
Figure 4-15
Enter the installation height of the camera.
Step 2
Enter the height of the lens; otherwise the camera-radar linkage effect will be reduced.
Select
Close
to turn off
Alarm Track
; otherwise you cannot calibrate the camera.
Step 3
Select installation methods from
Separate
and
Integrated.
Step 4
Add radar coordinates to calibrate radar.
Step 5
Set coordinates 10 m–20 m away from the PTZ camera and make sure they are
within the radar detection range.
Two people are required: Person A is on the site, and Person B doing configurations
on the Web. Keep A and B stay in contact.
Double-click the map to enter full screen, and then click
to add radar
1)
coordinates.
A walks until a green track appears.
2)
After A stops, the track of A will disappear and turn into an orange static track point.