12
4.2 Insert a Micro SD Card
The Micro SD card slot is located on the actual camera module.
Figure 4-2
1. Loosen the four (4) screws from the rear panel on the back of the dome. Remove the panel.
2. Unscrew the three (3) screws from the top of the camera module housing.
3. Remove the camera module housing.
4. Unscrew the four (4) module set screws, then remove the camera module.
5. Insert the Micro SD card into the appropriate slot on the camera module.
6. Re-assemble the camera module, secure back into the dome, and then replace the rear panel.
4.3 Mounting the Camera to a Wall
1. Place the PFB300S Wall Mount against the wall and mark the location of the center hole and the
four perimeter mounting holes.
2. Pre-drill the four perimeter holes as marked on the wall for the expansion bolts, using a drill bit
that is no wider than the expansion bolt.
3. Drill a 50-mm (approximately 2 in.) center hole to route the cables, if necessary.
4. Insert an expansion bolt into each pre-drilled perimeter hole, if necessary.
5. Wrap several turns of Teflon tape around the threads on the PFA110 Mount Adapter.
