Dahlert DT-WP-22, Instruction Manual

Page: 7 / 48

5
②
①
Drain water
tank
Instructions for use
• Installation can be done by yourself, please follow the instructions below.
• Please check and confirm whether there is a safety risk of dripping or water seepage at the
position of the socket and plug.
NOTE
First use instruction
1. Open the package, place it on the level
table, and install the water tray.
3. Steps of feeding water:
Add tap water to the raw water tank
(the larger one).
6. When using for the first time, clean the
internal pipeline after producing water.
Internal emptying: In the standby state, hold the
"Normal Temperature Water" and "Brewing
Milk" buttons at the same time for 3 seconds to
enter the drainage mode; at this time, the
normal temperature water icon flashes, and
other icons keep on. Press the Normal
Temperature Water button or wait for 3 minutes
after draining out water, it will automatically exit
the drainage mode.
2. Steps of taking out the water tank:
①
Remove the water tank cover;
②
Lift the handle of the water tank and pull
the water tank out, and then lift it out after it
is disconnected from the base.
Raw water
tank
4. Install the water tank:
①
Align the water tank with the socket on the
base and press it down;
②
After the water tank is pressed tightly, push
the water tank to the side of the machine body;
③
Install the water tank cover, at this time, the
top of the water tank cover is flush with the top
of the machine body.
5. The product starts to produce water:
During the water production process, if the
"Water Shortage" indicator is on, please
pour out the remaining water in the water
tank, fill the raw water tank with tap water,
and repeat the above steps.
① ②
③
3-5 times