33
DRAIN MOTOR AND VALVE REPLACEMENT
Wire Bracket
Adjustment
screw
• Lay the front of the washer on the floor.
• Loosen the adjustment screw and four bolts
mounting the drain motor.
• Take out the wire of drain motor from the bracket.
Valve frame
Bracket
Adjustment
screw
Valve lid
Valve
packing
Valve lid Pin Pin
Screw driver
• Separate the drain motor from the bracket.
• Turn the valve lid by using screw driver as shown in
figure and remove the valve lid from the valve frame.
BRAKE ADJUSTMENT
Brake lever
Adjustment screw
3mm
• Loosen the adjustment screw fastening the bracket
and place the adjustment screw to the brake lever
as shown in figure.
• Tighten the adjustment screw completely.
Brake lever
Adjustment bolt
Gear mechanism ass'y
Clutch lever
• Loosen the adjustment bolt and turn the adjustment
bolt until the end of the bolt touches to the b rake
lever.
• Tighten the lock nut and apply a small amount of
paint-lock.
NOTE:
1. The brake adjustment has been made at the factory, so that it is not to re-adjust. However, in case of insufficient
brake operation, perform the upper procedure.
2. Overtightening of the adjustment bolt will cause poor brake performance.
3. Undertightening of the adjustment bolt will cause continuous bracking and, thereby, cause the problems of the
motor during the spin cycle.
Drain motor