background image

 

DW-8000P 

                                                        Installation Guide

 

 

 

 

 

 

 

 

 

 

 

Copyright 

 2000, DAEWOO Corporation 

 All rights reserved.

 

 

This manual and software described in it are copyrighted with all rights reserved.  This manual may not 

be copied, in whole or in part, without the written consent of DAEWOO Corporation. 

DW-8000P

 is a 

trademark of DAEWOO Corporation. All other product names are trademarks and or registered 

trademarks of their respective companies. Part Number UG8000P-xx

 

 

FCC Statement 

 

This equipment has been tested and found to comply with the limits for a Class B digital device, 

pursuant to Part 15 of the FCC Rules.  These limits are designed to provide reasonable protection 

against harmful interference in a residential installation.  This equipment generates, uses and can radiate 

radio frequency energy and, if not installed and used in accordance with the instructions, may cause 

harmful interference to radio communications.  However, there is no guarantee that interference will not 

occur in a particular installation.  If this equipment does cause harmful interference to radio or television 

reception, which can be determined by turning the equipment off and on, the user is encouraged to try to 

correct the interference by one or more of the following measure: 

 

 

Reorient or relocated the receiving antenna. 

 

Increase the separation between the equipment and receiver. 

 

Connect the equipment into an outlet on a circuit different from that to which the receiver is 

connected. 

 

Consult the dealer or an experienced radio/TV technician for help. 

 

Shielded cables must be used to comply with FCC regulations. 

 

WARNING(Part15,Section 15.21) 

 

Changes or modifications not expressly approved by the manufacturer could void the user’s authority 

to operate the equipment. 

 

 

DW-8000P 

                                                        Installation Guide

 

 

ii 

BEFORE YOU START! ........................................................................................................................1

/

STEP 1 – GATHER SYSTEM AND SERVICE CONNECTION INFORMATION.........................2

/

S

YSTEM 

R

EQUIREMENTS

......................................................................................................................2

/

D

ETERMINING 

Y

OUR 

O

PERATING 

S

YSTEM

...........................................................................................2

/

D

ETERMINING 

Y

OUR 

C

ONNECTION 

A

DDRESS AND 

C

ONFIGURATION

...................................................3

/

STEP 2 – INSTALL THE ADSL MODEM CARD..............................................................................4

/

H

ARDWARE 

I

NSTALLATION

..................................................................................................................4

/

STEP3 – INSTALL THE DRIVERS.....................................................................................................5

/

D

RIVER 

I

NSTALLATION AND 

I

NTERNET 

S

ERVICE 

C

ONNECTION

...........................................................5

/

NDIS D

RIVER 

I

NSTALL FOR 

W

INDOWS 

95/98 ......................................................................................6

/

NDIS D

RIVER 

I

NSTALL FOR 

W

INDOWS 

2000 .......................................................................................9

/

NDIS D

RIVER 

I

NSTALL FOR 

W

INDOWS 

NT4......................................................................................10

/

APPENDIX A - CONNECTOR PINOUT...........................................................................................12

/

APPENDIX B - TROUBLE SHOOTING ...........................................................................................13

/

APPENDIX C - REMOVING DW-8000P DRIVERS........................................................................14

/

W

INDOWS 

95/98.................................................................................................................................14

/

W

INDOWS 

2000..................................................................................................................................14

/

W

INDOWS 

NT4.0 ...............................................................................................................................14

/

Summary of Contents for DW-8000P









Reviews: