27
(1) Cylinder
(2) lnlake air cooling ven! (back)
PROCEDURES TO BE PERFORMED AFTER EVERY
100 HOURS OF USE
1. Remove the muffler, insert a screwdriver into the vent, and wipe away any
carbon buildup. Wipe away any carbon buildup on the muffler exhaust vent
and cylinder exhaust port at the same time.
2. Tighten ali screws, bolts, and fittings.
3. Check to see if any oil or grease has worked its way in between the clutch
lining and drum, and if it has, wipe it away using oil-free, lead-free gasoline.
REFILLING TRIMMING LINE
1. For replacement line, use a diameter of 2.4mm(.095in).
The spool is capable for a line upto 6m(20ft) on the 10cm(4 head. Avoid
using a larger line as it may cut down the trimming performance.
WARNING
For safety reasons, do not use metalrelnforced line.
2. Pinch the slotted area on the both sides of the spool housing to unhook
the bottom cap.
3. Take out the spool and pull off the old line. Put one end of new line throu-
gh the spool hales and pull it until the length is equal between each part of
the line.
4. Wind up the line in the correct direction as indicated on the spool.
5. Hook each end of the line in the slot on the edge of the spool, and then
put the ends through the eyelets on the housing. Make sure that the spring
and the washers are in place.
6. While holding the spool against the housing, pull the line ends to release
them from the slot.
7. Line up the slot on the bottom cap with the hook on the housing, press
the cap against the housing until it clicks.
