11
INSTALLING CUTTING ATTACHMENT GUARD
Put the cutting attachment guard on the gearbox, attach it with the 4
screws and hardware provided.
(1) Cutting attachment guard
(2) Plate
(3) Screw
INSTALLING CUTTING HEAD
1. While locking the gear shatt, by inserting the supplied tool into the upper
holder on the gearbox, loasen and remove the hexagon nut (left-handed).
2. Then screw in the cutting head to the gear shaft over the holders Hand-ti-
ghten it securely.
HARNESS
WARNING
ALWAYS WEARTHE PROVIDED HARNESS WHEN USING THE MACHINE!
Always make sure the machine is hooked securely to the harness.
lf you don't, you will be unable to control the machi ne safely. This can result
in injury to yourself or others. Never use a harness with a detective quick
release or any other damage.
HOW TO WEAR
1. Wear the provided harness without twisted bands, with the hanger on
your right side.
BALANCE THE UNIT
1. Hook your machine to the hanger.
2. Adjust the bands of the harness to have the blade parallel to the ground
when standing in your normal working position to provide you most effecti-
veness and comfort on operating the machine.
3. In arder to preven! the hanger position to change during operation, turn
up the extra par! of the band from the buckle.
4. When correctly adjusted, check the correct working of the harnesses'
QUICK RELEASE.
QUICK HELEASE
The harness is equipped with a "QUICK RELEASE"devise. To release the
machine from the harness in emergency situations, please follow the proce-
dure as explained below.
WARNING
Make sure to check proper working of the QUICK RELEASE devlce BEFORE
operatlng the machlne. Make sure to hold the unit securely when using the
QUICK RELEASE.
While holding the unit by your right hand securely, press both sides of the
buckle. sides of the buckle.
