Daewoo DMB-1812LH, Service Manual

Page: 78 / 95

75
1 INDOOR UNIT
PROCEDURES PHOTOS
1. Stop the Air conditioner and disconnect the power cord from the wall
outlet.
2. Removing the Insert Grille and Frame Grille. (Fig 1~2)
1
Draw up the Insert Grille and remove it.
2
Loosen the screw fixed at the Cover Ter-Block.
3
Loosen two screw at the Frame Grille.
4
Remove the Frame Grille.
3. Removing the Control Box. (Fig 3)
1
Remove room and coil thermistors.
2
Disconnect the fan motor lead wire from connection at the
Control PCB.
3
Disconnect the stepping motor lead wire from connection at the
Control PCB.
4
Remove the select switch from connection at the Control PCB.
5
Loosen the screw fixed at ground wire.
6
Remove the Control Box
4. Removing the Drain Pan. (Fig 4)
1
Disconnect the Body drain hole. (left and right Body)
2
Disconnect three hook and remove the Drain Pan.
5. Removing the Indoor Evaporator. (Fig 5~6)
1
Remove the screw fixed at the indoor Evaporator of the Body.
2
Remove the hook fixed at the Bracket Pipe of the back of Body.
3
Remove Indoor Evaporator.
6. Removing the Cross Flow Fan. (Fig 7)
1
Remove set screw fixed at the Motor shaft.
2
Remove Cross Flow Fan.
7. Remove Motor IDU and Bearing Plastic.
10. DISASSEMBLY INSTRUCTIONS
Fig 1
Fig 3
Fig 4
Fig 5
Fig 6
DMB-1812LH (9K)
Fig 2
Fig 7