Diesel engine with electric starter system
Starting
The preparation of the diesel engine for the electric starting system is the same as the manual recoil type
.
a. Open the fuel cock
.
b. Set the speed governor lever to the start position.
c. Turn the start switch clockwise to the“Start”position
.
d. If the engine is started
,
immediately remove your hand away from the key switch
.
e. If the engine does not start after 10 seconds
,
wait awhile (about 15 seconds) before tying to start the
engine again
.
If you run the starter motor to long
,
the voltage of the accumulator will drop and the motor may be damaged
.
Keep the key switch in the “ON” position
Battery
a. Always check the liquid level of the battery every month
,
if the level is lower than the low limit mark
,
refill
the battery with distilled water till you reach the upper limit mark
.
If the liquid level in the battery is to low
,
the electric starter will not function to its best potential
.
Always keep
the level of the liquid in the baaery between the upper and lower linits
.
If there is too much liquid
,
the liquid
will splash onto other neary parts thereby mining the battery
.
Cold starting
If the engine is difficult to start in winter,take off the rubber seal plug and put 2cc of machine oil into
the hole
.
Notice
:
Engines supplied to the Torrid Zone will not contain the rubber plug
.
A solid plug is provided instead
.
9
Summary of Contents for DDA80
Page 9: ...8...
Page 19: ...9 EXPLOSION VIEWS AT2C E 4 AT3C E 4 18...
Page 21: ...AT4C E 4 20...
Page 23: ...AT3CLE 4 22...