Swing Aside Mount Assembly
DSAM4
Printed in Canada Manufactured by Daedalus Technologies in Canada
www.daessy.com
Page 2 of 6
Identify the Parts
Use the parts list and diagram below to identify each part and ensure all parts are included.
Part Code
Part Name
S22x3
Vertical S-bend Tube (22” long with 3”
offset)
Horizontal Tube
Assembly
Swing Aside Rotate Head, Tube &
Cable
ROP-RFCR
Removable Outer Piece & Receiver
UFCxxxxIP or
MH3/IPA
Frame Clamp
(*parts will vary based on
wheelchair, look for anything with an IP
or IPA engraved on it)
TUSB
Total Quick Release Base
Tools
Assembly Tools
Assembly Instructions
The Frame Clamp Assembly
This step requires 2 components:
•
Frame Clamp (UFCxxxxIP)
•
RFCR
The Frame Clamp varies depending on the type of wheelchair, it may not be exactly as shown, “Frame
Clamp” most commonly refers to UFCxxxxIP, but there are others all of which will include IP or IPA in
their part code. These instructions are
specific to mounts with a UFCxxxxIP;
other types of frame clamps will include
separate assembly instructions. Identify
the Frame Clamp and the RFCR.
•
Remove the cap from the Frame
Clamp.
•
Remove the Swivel Clamp from
the RFCR.
Align the grooves on the RFCR with the grooves on the frame clamp (photo below left). Put the non-
threaded half of the swivel clamp into the RFCR (with the bolts pushed through). Put the threaded half
into the Frame Clamp body and begin tightening the bolts, alternating between the two. Do not fully
tighten the bolts. The RFCR and the UFCxxxxIP should be able to swivel freely. See photos below.
