Swing Aside Mount Assembly
DSAM4
Printed in Canada Manufactured by Daedalus Technologies in Canada
www.daessy.com
Page 5 of 6
Setting the Swing Aside Direction
The DAESSY Swing Aside Mount is shipped with the Rotate Head setup
for installation on the Right side of a wheelchair. If necessary follow the
below steps to change for Left side installation.
Remove the center bolt from the blue direction pin.
Remove the pin, rotate it 180° until the diamond (
◊
) is positioned under the
‘L’, re-insert the pin.
Reinstall the center bolt and tighten snug but not too tight.
Install Horizontal Tube Assembly
The Swing Aside Rotate Assembly has three
lock-pin position holes around the silver collar.
The mount is shipped with the attached tube
positioned with the lock-pin in the center
position hole; this is the “in-use” position.
Remove the packing material from the tube hole
retaining the Pinch Clamp. Be careful not to
lose the Pinch Clamp.
Slide the Assembly onto the top of the Vertical
Tube. The Pinch Clamp must be aligned in its
hole so that it is even with the inside of the tube
hole to allow the tube to slide through
completely. Gently tighten the Pinch Clamp bolt.
Adjust the positioning of the Assembly so the lock-pin position holes
are oriented with one facing forward, one towards the inside of the
wheelchair, and one facing rearward. The assembly is shipped such
that this will position the horizontal tube across the chair (“in-use”
position).
Tighten the Pinch Clamp bolt firmly.
