(2) Disassemble a headlight socket by
pulling it out.
(3) Disassemble the rubber cover.
(4) Loosen the steel wire, and disassemble
the head light bulb.
HEADLIGHT BULB: 12V 55W
(5) Replace with new bulb.
(6) Install in the reverse order of remover.
<HEADLIGHT ILLUMINATION ANGLE>
Adjust headlight illumination angle by
turning an adjusting bolt on a headlight.
(Use type screwdriver.)
(1) Adjust the upper/lower by turning the
screw on outside.
(2) Adjust the right/left by turning the
screw on inside.
<TAIL/STOP LIGHT BULB>
(1) Loosen 2 tapping screws to disassemble
tail light lens.
(2) Press a bulb with a light force and rotate
it to counterclockwise to disassemble it.
(3) Replace it with new bulb. Apply reverse
order of disassembly for assembly.
TAIL/STOP LIGHT BULB : 12V 21/5W
29
CAUTION
I
llumination angle adjusted incorrectly
may dazzle a facing driver's eyes or
result in difficulty to show the forward.
CAUTION
When disassembling, care is to be taken
for ensuring that a tail light lens can not
be damaged.
When replacing a tail light lens, be sure
to assemble lens seal securely.
Summary of Contents for S1 - CATALOG
