DAELIM S1 - CATALOG, Owner'S Manual

Page: 31 / 67

<INSPECTION OF WINKER>
Turn a main switch “ON”. Check the lamp
for proper operation (front/rear and
right/left) and sound by operating the
switch, and also a lens for damage or
contamination.
<INSPECTION OF STOP LAMP>
Turn a main switch “ON”. Check a stop
lamp for proper operation by operating the
front wheel and the rear wheel brakes, and
also a lens for damage or contamination.
Be sure to turn a main switch "OFF"
prior to replacement of a bulb.
Use only a bulb of rated capacity.
After replacement with new bulb, check
for proper operation.
<HEADLIGHT BULB>
(1) Loosen 7 special screws and disassemble
the electric wire of the headlight and
remove the front cover.
28
LIGHTS AND WINKER INSPECTION
BULB REPLACEMENT METHOD
CAUTION
The lighting head light emits very hot
heat. If you touch with naked hand, it
may be burned.
When replacing head light lamp, stop
lame and winker lamp, use only a
bulb of rated capacity. Using a lamp
exceeding the rated capacity can
cause over-discharge of battery and
wire burning. It can lead a fire.
If the head light is turned off due to
aging while driving at night, it will
cause an accident by obstructing
driver’s view. Check the condition
daily.
If the tail light is off while driving at
night, it will cause an accident by
failure of notice by the other drivers.
Check the condition daily.
CAUTION
Care is to be taken to avoid leaving
fingerprints on a headlight bulb.
Failing to observe this may cause
early damage of the headlight bulb
resulted from concentration of heat.
Be sure to wear clean gloves when
replacing a bulb. If touched to it with
bare hands, clean it with a cloth
soaked with alcohol to prevent from
early damage.