45
<REMOVAL>
①
Loosen the 6 washer screws and
remove the air cleaner case cover.
②
Inspect the air cleaner element.
③
Install in the reverse order of removal.
<CLEANING>
●
Clean the air cleaner element in clean
oil, squeeze excess oil, and then, wra-
pping it in a dry cloth, squeeze it again.
●
Make sure all excess oil removed and
reassemble the air cleaner element.
OIL : SAE # 80 ~ 90
AIR CLEANER ELEMENT INSPECTION
●
Do not use gasoline or other ma-
terials having a low ignition point as
this can be a fire hazard.
●
If the air cleaner element is in-
adequately assembled, dust and other
waste materials can directly enter the
engine. This results in increased
cylinder wear and redu-ced power,
and reduced durability of the engine.
●
When washing the vehicle, be careful
not to allow water to get into the air
cleaner.
Difficulties in starting the engine
may result if this happens.
●
If the engine start is failed during
rain or after driving across water
pool, check to see if the water is
infiltrated in the air cleaner and clean
it.
●
Do not drive in the flooded area. If
the water enters the air cleaner or
engine, the vehicle may be subjected
to the rear-end collision due to the
power failure.
AIR CLEANER CASE COVER
SCREWS
Summary of Contents for A-FOUR -
