![background image](http://html1.mh-extra.com/html/daelim/a-four/a-four_brochure_3154126045.webp)
•
Be sure to turn the ignition switch OFF
when replacing the bulb.
•
Do not use bulbs other than that
specified.
•
After installing a new bulb, check that
the light operates properly.
[HEADLIGHT BULB]
①
Put your hand under the front under
cover and stretch it to the back of the
headlight bulb.
②
Remove the rubber cover.
③
Turn the socket clockwise, and
remove it.
④
Slightly press down on the bulb and
turn it counterclockwise.
⑤
Install a new bulb in the reverse order
of removal.
HEADLIGHT BULB : 12V 35W/35W
[TAIL/STOPLIGHT BULB]
①
Loosen the 2 tapping screws and
remove the tail light lens.
②
Install a new bulb in the reverse order
of removal.
TAIL/STOP LIGHT BULB : 12V 5W/21W
43
BULB REPLACEMENT
●
The light bulb becomes very hot
while the light is ON, and remain hot
for a while after it is turned OFF. Be
sure to let it cool down before
servicing.
●
Do not put finger prints on the
headlight bulb, as they may create
hot spots on the bulb and cause it to
break. Wear clean gloves while
replacing the bulb.
If you touch the bulb with your bare
hands, clean it with a cloth moistened
with alcohol to prevent its early
failure.
●
When replacing the head light lamp,
stop lamp and winker lamp, use only
specified lamps. Do not use the lamp
exceeded its capacity. the battery can
be overcharged and fire can be
occurred due to the burned wire.
SOCKET
RUBBER COVER
HEADLIGHT BULB
HEADLIGHT
ASS’Y
TAIL LIGHT LENS
SCREWS
TAIL LIGHT BULB
Summary of Contents for A-FOUR -
