7
In compliance with local codes, install an electrical junction
box near the hood’s electrical access holes.
1. In the cabinet or wall, drill 7/8” holes through which to
pass the electrical wiring.
2. See the last pages of this guide for wiring diagrams.
Suggested Area of Junction Box
Preparation and Setup
Installing the Electrical Source
• See the diagram below:
Top/Rear Electrical Access
Holes
for wire hole locations inside the hood.
• See
Wiring Diagrams
at the end of this document.
Hood
Junction Box Area
Top/Rear Electrical Access Holes
• The hood must be at least as wide as the cooktop.
• All dimensions must meet or fall within the specified mini-
mums.
• Dimensions given are minimum clearances unless other-
wise noted.
• All contact surfaces between the hood and cabinetry/
walls must be sturdy, solid, and at right angles.
• Install the hood and cooking appliance(s) so they can be
removed for service.
IMPORTANT
See the diagram for minimum installed distance from
the hood to the cooktop surface. The minimum specified
distance may be higher for the particular range or
cooktop in use. Check the manufacturers specifications
for the cooktop or range.
Meeting Installation Requirements
WARNING
• Observe all governing codes and ordinances during
planning and installation. Contact your local building
department for details. Use only ductwork accepted by
state, municipal, and local codes.
• To reduce risk of injury from reaching over a hot
appliance, do not place cabinets directly over the range.
Summary of Contents for RNHE36
Page 22: ...20 Wiring Diagrams RNHP3012 3018 RNHE3012 3018 Wiring Diagram 1 Blower 2 Light Models...
Page 23: ...21 Wiring Diagrams RNHP3612 3618 RNHE3612 3618 Wiring Diagram 1 Blower 3 Light Models...
Page 24: ...22 Wiring Diagrams RNHP4812 4818 RNHE4812 4818 Wiring Diagram 2 Blower 4 Light Models...
Page 25: ...23 Notes...
