Dacor ● 1440 Bridge Gate Drive, Diamond Bar, CA 91765 ● Tel: (800) 793-0093 ● FAX: (626) 403-3130 ● www.Dacor.com
Top Right Handle Installation
STEP 5:
Mount the handle to the right door by slid-
ing the holes on the back over the handle
mounting studs on the right door. Make sure
the set screw holes face toward the center
of the refrigerator. Loosen the set screws if
necessary to allow the handle to slide into
place.
STEP 6:
Carefully tighten the set screws into place
using the 3/32” Allen wrench. Be careful not
to scratch the finish.
STEP 7:
Check to make sure the handle is firmly
attached.
Top Left Handle Installation
STEP 8:
Mount the remaining handle to the left door
with set screw holes toward the center of the
refrigerator. Loosen the set screws if neces-
sary to allow the handle to slide into place.
STEP 9:
Open the left door while holding the handle
in place to prevent damage to the other
handle during step 10.
STEP 10:
Carefully tighten the set screws into place
using the 3/32” Allen wrench. Be careful not
to scratch the finish.
STEP 11:
Check to make sure the handle is firmly
attached.
Handle Mounting
Studs
Set Screw
Holes
Handle Mounting
Stud
Handle Mounting
Stud
Set Screw
Hole
Set Screw
Hole
