English
25
Using the rangetop
Ignition
LO
ME
D
OFF
H
I
Each control knob has a corresponding
burner. The burner location appears in
a small graphic next to each knob.
To light a burner, follow below steps.
1.
Push in and turn the knob counterclockwise to Lite (flame icon). The burner's igniter
will spark (click-click-click...) repeatedly until it lights (typically within 4 seconds). The
flame should burn evenly around the burner perimeter, except below a grate support
finger, where the flame height is reduced by Dacor’s Smart Flame feature. A normal
flame is steady and blue. Foreign material in the gas line, especially new construction,
may cause an orange flame initially that disappears with use. Small yellow tips on the
flames are normal when using LP gas. If a burner does not ignite, the igniter continues
to spark, or if the flame is not spread evenly around the burner cap, see
2.
Set the cookware on the grate.
3.
Adjust the flame to the level necessary to cook the food as desired.
NOTE
When a burner knob is set to LO, the igniter may keep sparking if the burner is cold,
then quit when it is warm. To reduce cold-burner sparking, set the knob to HIGH for 60
seconds, then set the flame to cook. The igniter sparks automatically if the flame is
distorted by a draft or household ventilation. Eliminate drafts or lower the ventilation
blower speed to minimize this issue.
Burner
location,
left rear