50
Removing the Range from the Wall for
Cleaning
1.
Turn the gas supply valve to the off position.
2.
Turn off power to the range at the circuit breaker
panel or fuse box.
3. Pull the range out from the wall.
Replacing the Range after Cleaning
1. Push the range back into the operating position.
Make sure the anti-tip bracket is engaged (see inside
cover).
2.
Turn on power to the range at the circuit breaker
panel or fuse box.
3.
Turn the gas supply valve to the on position.
Stainless Steel Surfaces
CAUTION
Always wipe stainless steel (silver colored) surfaces with the
grain. To prevent scratching, do not use abrasive cleaners or
scrubbers on stainless steel surfaces.
Using a soft cloth, clean metal surfaces with a mild solu-
tion of detergent and warm water. Rinse and dry with a
soft, lint-free cloth.
Cleaning Chrome Surfaces
CAUTION
To prevent scratching, do not use abrasive cleaners or scrubbers
on metal surfaces.
Using a soft cloth, clean metal surfaces with a mild solu-
tion of detergent and warm water. Rinse and dry with a
soft, lint-free cloth.
Glass (Interior and Exterior)
Use a mild glass cleaner to remove finger prints on glass
surfaces. You can also clean glass surfaces with Dacor
Cooktop Cleaning Creme. Use it according to the direc-
tions on the package.
You may scrub the oven light lens with the rough side of a
sponge and warm, soapy water. Be careful not to scratch
the lens.
Control Panel
CAUTION
Do not use abrasive cleaners or scrubbers on the control panel.
They will permanently damage the finish.
To avoid turning the oven on while
cleaning the control panel, activate the
lock-out feature. Touch and hold your
finger on the
CANCEL · SECURE
key
for five seconds. The keys will be disabled and
Locked
will appear on the display.
Clean the control panel with the soft side of a sponge
dampened with a mild solution of detergent and warm
water. Dry the control panel completely with a soft, lint-
free cloth.
To re-activate the control panel, touch and hold your
finger on the
CANCEL · SECURE
key for five seconds
Knobs and Trim Rings
CAUTION
• Do not soak the knobs in water or put them in the
dishwasher.
• Do not remove the trim rings from the range. Clean only the
outside edges of the trim rings. If you get moisture inside the
trim rings, damage to the knob lights or other parts of the
range can occur.
• Installing the range knobs in the wrong position may result
in damage to the griddle included with the range. The knobs
for the center burners are marked with the maximum griddle
settings.
• To prevent damage, do not use abrasive or corrosive
cleaners or applicators.
• Wash the knobs regularly with a solution of warm
soapy water. Dacor recommends hand dishwashing
liquid.
•
Turn the knobs to the off position to remove them for
cleaning or replacement.
• Grasp each knob and pull straight back, off of the
valve shaft.
• Clean the outside edges of the trim rings while the
knobs are removed. Wipe them with a soft damp rag.
•
To replace the knobs, align the “D” shaped opening on
the back of the knob with the end of the valve shaft.
Carefully push the
knob on until it stops.
Make sure you put the
two knobs with the
words “MAX GRIDDLE”
on the center burner
valve stems (closest to
the control panel).
Care and Cleaning
