18
L.C.D. SCREEN
The L.C.D. offers an easy to use screen that gives the owner / installer information regarding programming
and fault analysis. Whenever the motor is programmed or a fault occurs, refer to the screen for diagnostic
assistance. In certain cases the screen will give a message that reads “call gate technician’ this means that
the motor needs to be checked by an installer. The messages on the screen are generally self explanatory.
However the following table gives a description of the messages and their meaning.
MESSAGE
MEANING / ACTION
LOW BATTERY
THIS MESSAGE WILL SHOW AFTER INITIAL START UP, IF
THE LOW BATTERY MESSAGE REMAINS AFTER THE
MOTOR IS TRIGGERED :-
CHECK BATTERY VOLTAGE / CHECK CHARGER VOLTAGE
MAINS FAIL
CHECK THE MAINS POWER / CHECK TRANSFORMER /
CHECK CHARGER.
GATE CLOSED
THE GATE IS IN THE CLOSED POSITION.
GATE OPEN
THE GATE IS IN THE OPEN POSITION.
OBSTRUCTION
THE GATE HAS SENSED AN OBSTRUCTION. CHECK THE
WHEELS / ROLLERS/ RACK/ BRACKETS / FUSES./ FORCE
SETTING POTS.
AUTO-CLOSE ACTIVE
THE GATE IS SET TO AUTO CLOSE.
PARTY MODE
THE GATE IS IN AUTO-CLOSE OVERRIDE .
PROGRAM MODE
THE GATE IS IN PROGRAM MODE.
PROGRAMMING CLOSE POSI-
TION
THE GATE IS CLOSING WHILE PROGRAMMING.
MARKER OK
THIS MESSAGE WILL SHOW WHEN THE MAGNET PASSES
THE MARKER. THIS INDICATES THAT THE MARKER IS IN
WORKING ORDER.
PROGRAMMING OPEN POSITION
THE GATE IS OPENING WHILE PROGRAMMING.
PROGRAM COMPLETED
REMOVE LINK
THE PROGRAM IS COMPLETE. REMOVE THE PROGRAM
LINK.
SERVICE DUE
THE MOTOR REQUIRES A SERVICE.
CALL TECHNICIAN
THE MOTOR HAS EXPERIENCED A FAULT AND A TECHNI-
CIAN NEEDS TO INSPECT THE MOTOR.
BEAMS BLOCKED
THE INFRA-RED SAFETY BEAMS ARE BLOCKED / FAULTY/
THE BEAMS LINK HAS BEEN REMOVED.
L.C.D. SCREEN
Some of the messages below have been shortened to
show the main message. Certain messages will also
show the action needed.
