MNL-00008 [5]
Proprietary and Confidential
Page
35
of
55
grade cord rated 300V, 1.5mm
2
minimum. The power cord is the main disconnect device. Each
unit is equipped with an IEC 320 style power inlet, which incorporates two, 5x20mm fuses.
Note:
This unit comes equipped with a USB connection to be used to transfer and backup patient
data and to grant access to service menus with service USB key.
Note:
This unit should be on a dedicated circuit and all connections for power must be grounded.
Note:
Daavlin 1 Series CX and 1 Series CT Phototherapy equipment contain no operator
replaceable parts.
NUMBER
OF
LAMPS
VOLTS/HERTZ
AMP
RATING
& FUSE
OUTLET
4
100/125V 60/50Hz
2
3 Prong Grounded
4
200/240V 60/50Hz
1
Use Local Outlet
FUSE
TYPE
VOLTAGE
RATING
AMP
RATING
BREAKING
CAPACITY
Time-Delay
250V
2
35
Time-Delay
250V
1
35
22.2
Unpacking and Assembly
Open the top of the Box. Once open, place two hands on each side of the device and pull the 1
Series, including the foam packers on each end, out of the box. Remove the foam packers.
Note:
Be sure to remove all of the accessories, such as the manual, calibration output certificate,
power cord and eyewear before discarding the box.
Plug the “D” shape male fixture into the corresponding receptacle on the lower left
-hand side of
the device. Plug the unit into any grounded, three prong, electrical outlet. The unit is now ready
for use. To remove the power cord simply grasp the “D” shape
d plug and remove it from the 1
Series “D” shaped power inlet.
22.3
How to Position the Patient
22.3.1
Hand and Foot Treatments:
Position the device on a flat surface with the lamps facing up. Place the patient’s hands or feet
directly on top of the plastic lamp guard. For best results you should position the patient’s hands,
or feet, as close as possible to the center of the fixture.
Note:
When treating your hands and feet be careful to not place too much weight or pressure on
the acrylic surface. Excess pressure can cause the acrylic surface to crack and break.
