EN
introduction
Using the Combi-installation kit, you can drain both boiling water as well as warm water from your
boiling water unit.
These assembly instructions give you the proper directions for the correct connection and safe use
of the Combi installation kit. If the Combi installation kit is not connected according to the assembly
instructions, the warranty is voided. The manufacturer is not liable for damages resulting from an
unprofessionally executed assembly or one resulting from incorrect adherence to the directions.
pacKaging contents
1.
Check the packaging contents.
1x Mixing valve
1x Boiling water T-piece
1x 15 mm pipe
1x 12mm pipe
1x 15x12 mm knee joint
2x Washer
2x Extension hose
1x Reducer 15x12mm
1x Reducer 15x10mm
coMbi installation Kit asseMbly
Follow these five steps if your boiling water unit has already been installed
1.
Unplug the boiling water unit from the wall outlet.
2.
Turn the boiling water tap open until cold water flows from the tap. The installation is now
cold and safe.
3.
Turn the shut off valve, so that your water supply is now closed off
4.
Turn the boiling water tap open, to remove the pressure of the system. If you do not change
the position of the safety valve assembly, you could also close the tap of the safety valve
assembly.
5.
Disconnect the cold water hose from your safety valve assembly.
Onderhoud en garantie
Montage-instructie Combi installatieset
Daalderop BV Lingewei 2 Bedrijvenpark Medel 2702 Postbus 7 4000 AA Tiel Nederland
Tel. +31 (0)344 636 500 Fax +31 (0)344 620 901 E-mail: [email protected] www.daalderop.nl
A
B
C
H
D
E
F
G
I
2x
1x
1x
1x
1x
1x
2x
1x
1x
B
E
F
A
D
C
G
H
I
Figure 1
Assembly instructions Combi installation kit
Introduction and Assembly
07.98.92.033 Handleiding Combi Installatieset_NMRS.indd 7
5-7-10 16:29
