3
ELECTRICAL INSTALLATION
Internal wiring has been completed at the factory. Installer must route power to the wall switch and to the junction box
located on the left end of the screen case.
standard installation is for a single 120VaC or 240VaC wall switch to control the screen. optional Control units may have
been ordered. Wiring diagrams for the built-in VPI and low voltage control are included in these instructions. Refer to
additional instructions for the external VPI, external low voltage control, sCb-100 and sCb-200. Refer to the appropriate
wiring diagram for your screen.
Test installation by running screen up and down a few times. be prepared to stop screen.
standard duty Cycle: 1mIn. on / 3 mIn. off.
NOTE: Must be installed in accordance with the requirements of the Local Building Codes, the Canadian Electrical Code (CEC), CAN/
CSA C22.1 and the National Electric Code (NEC), NFPA 70.
SCREEN AdjUSTMENT
screen travel is stopped automatically in the down and up positions by the limit switches that are preset at the factory. If
it's necessary to adjust for more or less drop follow the steps below.
CAUTION: Do not adjust for more drop than what was ordered. At least 1-1/2 wraps of fabric must remain on the roller. This
screen comes standard with 12" black at the top.
s
!
CONTACT DA-LITE AT 800-622-3737 OR 574-267-8101 IF SCREEN MOTOR NEEDS ADjUSTMENT.
s
!
