Da-Lite ExecutiveElectrol, Instruction Book

Page: 2 / 12

2
Pre-Installation
Installation
Important Safety Instructions
When using your video equipment, basic safety precautions should always be followed, including the following:
1. Read and understand all instructions before using.
2. Position the cord so that it will not be tripped over, pulled, or
contact hot surfaces.
3. If an extension cord is necessary, a cord with a current rating
at least equal to that of the appliance should be used. Cords
rated for less amperage than the appliance may overheat.
4. To reduce the risk of electric shock, do not disassemble this
appliance. Contact an authorized service dealer when repair
work is required. Incorrect reassembly can cause electric
shock when the appliance is used subsequently.
5. The use of an accessory attachment not recommended by
the manufacturer may cause a risk of fire, electric shock, or
injury to persons.
1. Carefully unpack screen and remove outer wrapping
from case.
2. Remove fabric and cardboard strips from access door.
3. Remove access door by gently prying from middle section.
4. FOR TYPE 3 INSTALLATION ONLY, remove wood strips along
bottom edge of screen case.
5. Remove instruction cover (Fig. 1). Remove, reverse, and
remount Center Support Brackets.
6. Do not remove metal shipping brace (secures roller),
wrapping paper or tape until screen is installed.
NOTE: Screen is not centered in box. Screen is set
22" from motor end.
7. Make sure to recheck measurement of screen location
before installation.
1. Install screen by raising unit into position between joists
at one end only. Install one lag screw in each mounting
bracket. Secure opposite end. Support center of the screw
using the brackets.
2. Level unit lengthwise with a carpenter’s level and
a plum level.
CAUTION! Do not secure access door or seal in unit
until screen has been secured in position and properly
tested for satisfactory operation. Do not fit unit so tightly
that the screen surface drop door binds. Door drops by
gravity only.
3. If you are going to cover screen door with paneling or other
materials, allow access (suitable holes or a plug) to screws
when servicing.
4. Remove shipping brace by removing 3 hex head
screws (Fig. 2).
CAUTION! Do not cut wrapping paper or tape
with knife or any sharp tool. Remove by hand.
5. Remove tape strips and release fabric (Fig. 2). Picture surface
should hang freely (Fig. 3). Remove any tape left hanging on
back of fabric. Bottom edge should be positioned between
bottom edge of case and center of roller.
Case
Instruction Cover
Fabric Door
Access Door
Figure 1
Figure 2
Shipping Brace
(Not On 3" Roller)
Hex Head
Screws
Tape Strip