•
If you store your collar in a drawer, on a shelf or other flat
surface, keep your key ring magnet separated and away
from the collar receiver to help prevent accidental activa-
tion. Occasionally check your collar, when not in use or
stored, to ensure that it has not been activated.
•
As with any electronic device which uses replace-
able/disposable type batteries, it is always recommended
that you keep an extra set of batteries on hand. This will
prevent any training delays when the batteries need to
be replaced.
How to Test Your Collar
1. Place the contact terminals
of the test lamp firmly onto
the electrodes of the re-
ceiver.
2. Set the stimulation to level 5
or 6.
3. Use the serrated edge of the
test light and gently rub it
across the sensor (black
plastic center post).
4. A red light on the test light
should light up.
NOTE
- When rubbing the serrated edge of the test
light across the sensor, do not press down hard. In-
stead, run the tester all the way from one end to the
other with a quick motion using a very light amount of
downward pressure. Do not be discouraged if it
takes a few tries to get the hang of it.
Summary of Contents for Ultra Min-e 2090
Page 1: ...Owner s Manual ...
