D-Link xStack Storage DSN-5210, Hardware Reference Manual

Page: 41 / 48

DSN-5000 series Hardware Reference Guide 33
A.4 Replacing the I/O Module on the Expansion Array
Use the following procedure to replace the I/O module on the expansion array.
1. Power down the DSN-5000 series primary and expansion array and remove the power
cords from the back panel.
2. Squeeze down on the top of the levers on either side of the I/O module on the expansion
array and pull down to disengage the module, then pull the module straight out of the
enclosure.
3. Install a replacement I/O module in the expansion array by keeping the levers on the
left and right sides down, then slide the module into the enclosure until you feel it
engage into place.
4. Replace the power cords and power on the DSN-5000 series primary array and expansion
array.
Figure A-5. Removing the I/O Module on the Expansion Array (Slot #0 shown)